ACT-48 · Replacement of probe knurled prisoners (drag shaft).
Description
With the machine turned off and disconnected from the tractor, remove the plastic probe fairing from the inter-vine, then release the studs holding the shaft to which the rod is attached, release the traction spring and loosen the screw that presses the compression spring. You can now remove the drive shaft by pulling it upwards. Put a new shaft in place and re-clamp the rod shaft with the studs, position and tension the springs after this operation.
Compatible machine families
BIOCOMBICULTIFRUTDAVICULTORFRONT-XLID-FRONTID-NAMICID-WEEDERID-XLVENTRALX-TREME
Maintenance that uses this task
| Maintenance | Machine families |
|---|---|
| MM-7 · Maintenance at 800 hours | AL-CALHALMOND-3BASIC-LBASIC-PBIOCOMBICONDORCULTIFRUTDAVICULTORDAVICULTOR 2.0DEADEFEAHECO-CUTECOFEEDECOTRIMEFIC-PFRONT-XLFRTI-DUSTI-GREENID-AID-DUALID-FRONTID-NAMICID-REVID-REXID-ROLLID-TERRAID-WEEDERID-XLLAT&GONAKIRIOLIXPFOPFPPFS-iPFS-i-CPROFEEDPRUNEXPV-LPV-L-RPV-SETOPV-TUNELPV-TUNEL-RPV-VIEWPV-VIEW-RPVORANNAREV-2RUNDERSURFEEDTD-FASTTD-KERRTD-LTD-RTD-SOTD-VIDTRIM-PROV-DUALV1V5VENTRALX-TREMEX10-TILLERgdgd |
Associated resources
There are no associated resources
Available in a future release