ACT-60 · Replacement of inductive sensor wiring of the probe.

Description

With the machine turned off and disconnected from the tractor, remove the plastic probe fairing from the intercep, locate the inductive sensor that will be on a folded bracket pointing at the eccentric of the shaft. Remove the cable connected to the inductive and follow the cable along its route to the junction box by releasing the cable ties that hold it attached to the patch cords. Release the cable at its end of the junction box and replace it with a new one by bridling it to the hoses as the one that has been removed was.

Compatible machine families

BIOCOMBICULTIFRUTDAVICULTORFRONT-XLID-FRONTID-NAMICID-WEEDERID-XLVENTRALX-TREME

Maintenance that uses this task

MaintenanceMachine families
MM-8 · Maintenance at 2,400 hours
AL-CALHALMOND-3BASIC-LBASIC-PBIOCOMBICONDORCULTIFRUTDAVICULTORDAVICULTOR 2.0DEADEFEAHECO-CUTECOFEEDECOTRIMEFIC-PFRONT-XLFRTI-DUSTI-GREENID-AID-DUALID-FRONTID-NAMICID-REVID-REXID-ROLLID-TERRAID-WEEDERID-XLLAT&GONAKIRIOLIXPFOPFPPFS-iPFS-i-CPROFEEDPRUNEXPV-LPV-L-RPV-SETOPV-TUNELPV-TUNEL-RPV-VIEWPV-VIEW-RPVORANNAREV-2RUNDERSURFEEDTD-FASTTD-KERRTD-LTD-RTD-SOTD-VIDTRIM-PROV-DUALV1V5VENTRALX-TREMEX10-TILLERgdgd

Associated resources

There are no associated resources

Back to Maintenance actions

Available in a future release