ACT-123 · RPM inductive sensor wiring change.

Description

With the machine turned off and disconnected from the tractor, disconnect the inductive located near the cutter bar motor and unbridle it, disconnect from the sensor distributor and replace with the new wiring. Once connected to the sensor distributor, the sensor cable must be re-bridled and connected to the inductive. CARLOS SAYS THAT IT IS SOMETHING THAT NO ONE IS GOING TO DO UNTIL IT BREAKS.

Compatible machine families

I-DUSTID-REXPFPPFS-iV-DUALV1V5

Maintenance that uses this task

MaintenanceMachine families
MM-11 · Maintenance at 4,800 hours
BIOCOMBICULTIFRUTDAVICULTOREAHI-DUSTID-FRONTID-NAMICID-REXID-WEEDERID-XLPFPPFS-iV-DUALV1V5VENTRALX-TREME

Associated resources

There are no associated resources

Back to Maintenance actions

Available in a future release