ACT-2 · Lubrication of the bearings and shafts of the cutting module.

Description

With the machine switched off and disconnected from the tractor, apply 2-3 pumps with a manual grease pump on the grease fittings that you will find on the bearings of the cutting module discs as well as those located on the bottom of the axle. Clean the excess afterwards to avoid unnecessary accumulation of grease outside the application area.

Compatible machine families

ALMOND-3BASIC-LCONDORID-REXNAKIRIOLIXPFPPFS-iPV-LPV-SETOPV-TUNELPV-VIEWV-DUALV1V5

Maintenance that uses this task

MaintenanceMachine families
MM-2 · Maintenance at 40 hours
AL-CALHALMOND-3BASIC-LBASIC-PBIOCOMBICONDORCULTIFRUTDAVICULTORDAVICULTOR 2.0DEADEFEAHECO-CUTECOFEEDECOTRIMEFIC-PFRONT-XLFRTI-DUSTI-GREENID-AID-DUALID-FRONTID-NAMICID-REVID-REXID-ROLLID-TERRAID-WEEDERID-XLLAT&GONAKIRIOLIXPFOPFPPFS-iPFS-i-CPROFEEDPRUNEXPV-LPV-L-RPV-SETOPV-TUNELPV-TUNEL-RPV-VIEWPV-VIEW-RPVORANNAREV-2RUNDERSURFEEDTD-FASTTD-KERRTD-LTD-RTD-SOTD-VIDTRIM-PROV-DUALV1V5VENTRALX-TREMEX10-TILLERgdgd

Associated resources

There are no associated resources

Back to Maintenance actions

Available in a future release