ACT-65 · Replacement of the arm springs.

Description

With the machine turned off and disconnected from the tractor and the cultivator slightly suspended (without the arms resting on the ground), loosen the nut on the stem that tightens the spring as much as possible. Using appropriate pliers, remove the circlip from the pin that holds the shank to the arm and remove the pin. Remove the shank from the cups by releasing the spring. Replace the spring with a new one. In the replacement process, check the condition of the end of the shank opposite the flask and the bushing that goes through the shank at its end. If wear is noticed, it is vitally important to replace any of these elements.

Compatible machine families

ALHCOMBICULTIFRUTDAVICULTORID-ALAT&GOX10-TILLER

Maintenance that uses this task

MaintenanceMachine families
MM-8 · Maintenance at 2,400 hours
AL-CALHALMOND-3BASIC-LBASIC-PBIOCOMBICONDORCULTIFRUTDAVICULTORDAVICULTOR 2.0DEADEFEAHECO-CUTECOFEEDECOTRIMEFIC-PFRONT-XLFRTI-DUSTI-GREENID-AID-DUALID-FRONTID-NAMICID-REVID-REXID-ROLLID-TERRAID-WEEDERID-XLLAT&GONAKIRIOLIXPFOPFPPFS-iPFS-i-CPROFEEDPRUNEXPV-LPV-L-RPV-SETOPV-TUNELPV-TUNEL-RPV-VIEWPV-VIEW-RPVORANNAREV-2RUNDERSURFEEDTD-FASTTD-KERRTD-LTD-RTD-SOTD-VIDTRIM-PROV-DUALV1V5VENTRALX-TREMEX10-TILLERgdgd

Associated resources

There are no associated resources

Back to Maintenance actions

Available in a future release